IF SAW Filter
Part Number Package Application Last Modified
811-SL200.0M-05 11.6 x 5.0 SMD Base Station & Repeater Apr 18, 2007
.
TYPE :
200.0 MHz Bandpass SAW Filter
Low Loss

PART NUMBER :
811-SL200.0M-05
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency - 200.0 - MHz
Insertion Loss at Fo - 11.8 13.0 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Bandwidth at -1.0 dB 4.5 5.09 - MHz
Bandwidth at -3.0 dB 5.5 5.92 - MHz
Bandwidth at -40.0 dB - 8.68 10.0 MHz
Relative Attenuation: (Ref 200MHz) - - - -
At 170 / 230 MHz 50 57 - dB
Ultimate Rejection 45 - - dB
Amplitude Ripple (Fo +/- 2.05MHz) - 0.6 1.0 dBp-p
Group Delay Variation (Fo +/- 2.05MHz) - 100 150 nsec
Absolute Delay at Fo - 0.98 - µsec
Temperature Coefficient - -23 - ppm/C
In/Out Return Loss at Fo - - - dB
*With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary.
.
PACKAGE OUTLINE (mm) TEST FIXTURE

PIN Description IN-1,OUT-7, GROUND-2,3,4,5,6,8,9,10

 
FREQUENCY RESPONSE
Part No.:
811-SL200.0M-05

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map