IF SAW Filter
Part Number Package Application Last Modified
807-SL300.0M-20 7.0 x 5.0mm SMD Base Station & Repeater Apr 18, 2007
.
PART NUMBER :
807-SL300.0M-20

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency - 300.0 - MHz
Insertion Loss - 10.30 15 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Bandwidth -1.0 dB 20.0 21.95 - MHz
Bandwidth -3.0 dB 21.0 23.55 - MHz
Bandwidth -40.0 dB - - 31.0 MHz
Amplitude Ripple (Fo +/- 2.5MHz) - 0.4 0.7 dBp-p
Amplitude Ripple - 0.7 1.5 dBp-p
Group Delay Variation - 65 120 nsec
Group Delay Variation - 50 100 nsec
Absolute Delay at Fo - 0.510 1.0 µsec
Relative Attenuation - - - -
Lower Sidelobe 40 - - dB
Upper Sidelobe 40 - - dB
Ambient Temperature - 25 - C
Temperature Coefficient - -94 - ppm/C
* No Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, E, F, G, H, J Ground
I In
D Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

TEST FIXTURE

 

 
FREQUENCY RESPONSE
Part No.:
807-SL300.0M-20

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map