IF SAW Filter
Part Number Package Application Last Modified
835-IF65.0M-F 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007
TYPE :
65.0 MHz Bandpass Filter
 

PART NUMBER :
835-IF65.0M-F
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency - 65.0 - MHz
Insertion Loss - 20.0 21.5 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
1.0dB Bandwidth 9.35 9.40 - MHz
3.0dB Bandwidth 9.50 9.78 - MHz
50.0dB Bandwidth - 11.45 11.50 MHz
Amplitude Ripple - 0.5 0.9 dBp-p
Group Delay Variation - 40 120 ns
Absolute Delay at Fo - 2.36 - µs
Ultimate Rejection 50 55 - dB
Temperature Coefficient - -72 - ppm/C
* with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)
PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case
TEST ENVIRONMENT
Source & Load Impedance: 50 ohm
FREQUENCY RESPONSE
Part No.:
835-IF65.0M-F

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map