IF SAW Filter
Part Number Package Application Last Modified
835-IF240.0M-C 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007
TYPE :
240.0 MHz Bandpass Filter
 

PART NUMBER :
835-IF240.0M-C
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency 239.85 240.00 240.15 MHz
Insertion Loss - 26.3 28.0 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
1.0dB Bandwidth 4.0 4.21 - MHz
3.0dB Bandwidth 4.2 4.42 - MHz
40.0dB Bandwidth - 5.25 5.4 MHz
Amplitude Ripple (Fo+/-1.875 MHz) - 0.6 1.0 dBp-p
Group Delay Variation (Fo+/1.875 MHz) - 100 200 ns
Absolute Delay at Fo - 3.08 - µs
Ultimate Rejection - 50 - dB
Temperature Coefficient - -0.03 - ppm/C
Storage Temperature -40 - +85 C
Operating Temperature -30 - +70 C
* with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)
PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case
TEST ENVIRONMENT
Source & Load Impedance: 50 ohm
FREQUENCY RESPONSE
Part No.:
835-IF240.0M-C

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map