IF SAW Filter
Part Number Package Application Last Modified
835-IF167.5M-A 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007
TYPE :
167.5 MHz Bandpass Filter
 

PART NUMBER :
835-IF167.5M-A
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) 167.35 167.5 167.65 MHz
Insertion Loss at Fo - 24.5 26.0 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Temperature Coefficient - -23 - ppm/C
Amplitude Ripple - 0.55 1.0 dBp-p
Bandwidth at 3.0 dB 9.8 10.0 - MHz
Ultimate Rejection -
Fo + 200 KHz - 9.4 - dB
Fo + 400 KHz - 21.2 - dB
Fo + 600 KHz - 42.3 - dB
Fo + 1 MHz 50 62 - dB
Adsolute Delay at Fo - 3.12 - us
* with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)
PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case
TEST ENVIRONMENT
Source & Load Impedance: 50 ohm
FREQUENCY RESPONSE
Part No.:
835-IF167.5M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map