IF SAW Filter
Part Number Package Application Last Modified
813-SL70.0M-20 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL70.0M-20

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) 69.8 70.0 70.2 MHz
Insertion Loss at Fo - 15.5 16.5 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Temperature Coefficient - -94 - ppm/C
Amplitude Ripple - 0.5 1.0 dBp-p
1dB Bandwidth 18.7 18.99 - MHz
3dB Bandwidth 19.7 20.05 - MHz
40dB Bandwidth - 24.08 25.5 MHz
Relative Attenuation: -
Lower sidelobe 40 45 - dB
Upper sidelobe 40 45 - dB
Absolute Delay at Fo - 0.85 - us
IN/OUT Return Loss at Fo - - - dB
Group Delay Variation - 25 50 ns
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL70.0M-20

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map