IF SAW Filter
Part Number Package Application Last Modified
813-SL62.5M-10 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL62.5M-10

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) - 62.5 - MHz
Insertion Loss at Fo - 15.5 17.0 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Temperature Coefficient - -94 - ppm/C
Amplitude Ripple - 0.4 1.0 dBp-p
1dB Bandwidth 9.5 9.85 - MHz
3dB Bandwidth 10.2 10.6 - MHz
40dB Bandwidth - 13.9 15.0 MHz
Relative Attenuation: -
Lower sidelobe 40 48 - dB
Upper sidelobe 40 45 - dB
Absolute Delay at Fo - 0.92 - us
IN/OUT Return Loss at Fo - - - dB
Group Delay Variation - 20 100 us
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL62.5M-10

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map