IF SAW Filter
Part Number Package Application Last Modified
805-SL482.0M-20

5.0 x 5.0 SMD

Communication Jan. 01, 2007
.
TYPE :
IF SAW Filter

PART NUMBER :
805-SL482.0M-20
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
Minimum Typical Maximum Units
Center Frequency (Fo) - - 482.0 - MHz
Insertion Loss @ Fo - 8.7 12.0 dB
Relative Attenuation
Fo ± 15.0 MHz
5 8 -  dB
Fo ± 140.0 MHz
40 45 -
Bandwidth at -1.0 dB - 22.5 23.0 - MHz
Bandwidth at -3.0 dB - - 26.5 -
Bandwidth at -40.0 dB - - 37.5 39.0
Amplitude Ripple
472 ~ 492 MHz
- 0.8 1.0 dBp-p
Passband Phase Ripple
472 ~ 492 MHz
- 7 10 DEG.
Absolute Delay @ Fo - 0.35 - µsec
Source Impedance (Balanced)* - - 100 - ohm
Load Impedance (Balanced)* - - 100 - ohm
Temperature Coefficient - - -94 - ppm/șC
Operating Temperature - -0 - +50 șC
Storage Temperature - -35 - +85 șC
* With Matching Network (Ref. Testing Environment Circuit as shown below)
** Custom SAW IF Filters available. Contact Oscilent for assistance.
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

In

C In
D Ground
E Ground
F Out
G Out
H Ground
 
TEST FIXTURE
L1 = 18nH C1 = 27pF
L2 = 12nH C2 = 36pF
Source/Load Impedance = 100 ohms
 
FREQUENCY RESPONSE
 
Part No.:
805-SL482.0M-20

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map