IF SAW Filter
Part Number Package Application Last Modified
867-SL201.0M-11A 7.0 x 5.0 SMD IF SAW Filter January 2011

PART NUMBER :
867-SL201.0M-11A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 200.75 201.00 201.25 MHz
Insertion Loss Fo - 12.70 15.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Fo 4.5 MHz - 0.3 0.8 dB
Group Delay Ripple Fo 4.5 MHz - 40 80 nsec
Temperature Coefficient - - -18 - ppm/C
Bandwidth -1 dB 11.00 11.35 - MHz
-3 dB - 12.50 -
-40 dB - 16.75 17.20
Absolute Delay Fo - 0.69 - usec
Relative Attenuation Lower Sidelobe 40 50 - dB 
Upper Sidelobe 40 50 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 2, 3, 5, 6, 7, 8, 9, 11, 12 Ground
10 Input
4 Output

 


TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
867-SL201.0M-11A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map