IF SAW Filter
Part Number Package Application Last Modified
867-SL174.0M-08A 7.0 x 5.0 SMD IF SAW Filter January 2011

PART NUMBER :
867-SL174.0M-08A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 173.80 174.00 174.20 MHz
Insertion Loss Fo - 12.70 15.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Fo 3.0 MHz - 0.3 0.8 dB
Group Delay Ripple Fo 3.0 MHz - 30 80 nsec
Temperature Coefficient - - -18 - ppm/C
Bandwidth -1 dB 8.00 8.15 - MHz
-3 dB - 9.35 -
-40 dB - 13.30 14.00
Absolute Delay Fo - 0.70 - usec
Relative Attenuation Lower Sidelobe 40 45 - dB 
Upper Sidelobe 40 50 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 2, 3, 5, 6, 7, 8, 9, 11, 12 Ground
10 Input
4 Output

 


TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
867-SL174.0M-08A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map