IF SAW Filter
Part Number Package Application Last Modified
867-SL120.0M-A 7.0 x 5.0 SMD IF SAW Filter January 2011

PART NUMBER :
867-SL120.0M-A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 120.0 - MHz
Insertion Loss Fo - 8.0 9.0 dB
Maximum DC Voltage - - - 3 V
Maximum Input Power - - - 20 dBm
Operating Temperature - -20 - +85 C
Storage Temperature - -40 - +105 C
Source Impedance single ended * - 600 - ohm
Load Impedance single ended * - 400 - ohm
Amplitude Ripple Fo 0.5 MHz - 0.5 1.5 dB
Group Delay Ripple Fo 0.5 MHz - 25 100 nsec
Temperature Coefficient - - -23 - ppm/C
Bandwidth -3 dB - 4.0 - MHz
Absolute Delay Fo - 0.27 - usec
Template on the amplitude, reference is minimum insertion loss Fo 3.95MHz 15 18 - dB 
Fo -10MHz 0.63MHz 30 35 -
Phase Linearity Fo 0.5 MHz - 0.6 2.5 deg RMS
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
B, D, F, H Ground
A, G Input
C, E Output

 


TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
862-SL120.0M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map