IF SAW Filter
Part Number Package Application Last Modified
821-IF70.0M-15A 20 x 9.8 SMD IF SAW Filter January 2011

PART NUMBER :
821-IF70.0M-15A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 70.0 - MHz
Insertion Loss Fo - 19.7 22.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - 0 - +50 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Fo 6.925MHz - 0.47 0.90 dB
Group Delay Ripple Fo 6.925 MHz - 45 80 nsec
Temperature Coefficient - - -20 - ppm/C
Bandwidth -1 dB 13.85 15.35 - MHz
-3 dB - 15.85 -
-40 dB - 17.65 18.20
Absolute Delay Fo - 2.0 - usec
Relative Attenuation Lower Sidelobe 50 55 - dB 
Upper Sidelobe 50 55 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I Ground
J In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
821-IF70.0M-15A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map