IF SAW Filter
Part Number Package Application Last Modified
813-SL96.0M-35 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL96.0M-35

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 96.0 - MHz
Insertion Loss Fo - 16.8 18.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation - - 1.2 2.0 dB
Amplitude Ripple Fo 2.5 MHz - 0.4 0.7 dB
Group Delay Variation - - 65 120 nsec
Group Delay Variation Fo 2.5 MHz - 38 70 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB 35.0 36.0 - MHz 
-3 dB 36.0 36.8 -
-30 dB - 40.0 41.0
Absolute Delay Fo - 0.942 - usec
Relative Attenuation - 40 47 - dB
Ambient Temperature - - 25 - C
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL96.0M-35

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map