IF SAW Filter
Part Number Package Application Last Modified
813-IF91.25M-02A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-IF91.25M-02A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 91.25 - MHz
Insertion Loss Fo - 20.3 22.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - 0 - +60 C
Storage Temperature - -20 - +70 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 0.75 MHz - 0.17 1.00 dB
Group Delay Variation Fo 0.75 MHz - 52 100 nsec
Temperature Coefficient - - -0.03 - ppm/C
Bandwidth -1 dB 1.50 2.08 - MHz 
-30 dB - 3.42 -
-45 dB - 3.60 5.50
Absolute Delay Fo - 1.80 - usec
Relative Attenuation Fo 1.75 MHz - 32 - dB
Fo 2.75 MHz - 55 -
Ultimate Rejection - - 45 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF91.25M-02A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map