IF SAW Filter
Part Number Package Application Last Modified
813-SL90.0M-29A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL90.0M-29A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 89.85 90.00 90.15 MHz
Insertion Loss Fo - 13.40 15.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 13.5 MHz - 0.3 0.9 dB
Group Delay Variation Fo 13.5 MHz - 30 50 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth 1 dB 28.00 29.17 - MHz 
-3 dB - 30.15 -
-40 dB - 34.35 35.00
Absolute Delay Fo - 0.92 - usec
Ultimate Rejection Level - 40 47 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL90.0M-29A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map