IF SAW Filter
Part Number Package Application Last Modified
813-SL85.1M-20A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL85.1M-20A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 85.1 - MHz
Insertion Loss Fo - 11.50 13.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 9.22MHz - 0.40 0.95 dB
Group Delay Variation Fo 9.22 MHz - 35 50 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB - 20.50 - MHz 
-3 dB 21.20 21.35 -
-40 dB - 25.10 25.30
Absolute Delay Fo - 0.88 - usec
Ultimate Rejection - 40 48 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL85.1M-20A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map