IF SAW Filter
Part Number Package Application Last Modified
813-SL75.0M-29A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :

813-SL75.0M-29A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 74.85 75.00 75.15 MHz
Insertion Loss Fo - 17.0 18.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 13.5 MHz - 0.35 0.80 dB
Group Delay Variation Fo 13.5 MHz - 20 50 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB 29.0 29.6 - MHz 
-3 dB 30.0 30.8 -
-40 dB - 36.2 37.0
Absolute Delay Fo - 0.84 - usec
Relative Attenuation Lower Sidelobe 40 48 - dB
Upper Sidelobe 40 45 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL75.0M-29A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map