IF SAW Filter
Part Number Package Application Last Modified
813-SL75.0M-26B 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL75.0M-26B

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.1 - MHz
Insertion Loss Fo - 15.4 16.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 12.48 MHz - 0.45 0.80 dB
Group Delay Variation Fo 12.48 MHz - 29 60 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth 1 dB 26.00 26.40 - MHz 
-3 dB - 27.17 -
-15 dB - 28.81 30.00
Absolute Delay Fo - 1.13 - usec
Relative Attenuation 59.5 45 61 - dB
89.5 12 12.6 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL75.0M-26B

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map