IF SAW Filter
Part Number Package Application Last Modified
813-SL75.0M-20G 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL75.0M-20G

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.0 - MHz
Insertion Loss Fo - 13.5 15.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 9.75 MHz - 0.3 1.0 dB
Group Delay Variation Fo 9.75 MHz - 35 50 nsec
Ultimate Rejection - 42 48 - -
Bandwidth -1 dB 20.0 20.6 - MHz 
-3 dB 21.0 21.4 -
-40 dB - 25.1 25.5
Absolute Delay Fo - 0.95 - usec
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL75.0M-20G

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map