IF SAW Filter
Part Number Package Application Last Modified
813-SL75.0M-20E 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL75.0M-20E

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 74.5 75.0 75.5 MHz
Insertion Loss Fo - 16.3 17.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation - - 0.5 1.0 dB
Group Delay Variation - - 40 55 nsec
Temperature Coefficient - - - 94 ppm/C
Bandwidth -1 dB - 20.5 - MHz 
-3 dB 21.0 21.6 -
-40 dB - 25.7 26.5
Absolute Delay Fo - 0.75 - usec
Relative Attenuation Lower Sidelobe 40 45 - dB
Upper Sidelobe 40 45 -
Ambient Temperature - - -25 - C
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL75.0M-20E

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map