IF SAW Filter
Part Number Package Application Last Modified
813-SL75.0M-10B 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL75.0M-10B

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.0 - MHz
Insertion Loss Fo - 13.0 15.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +60 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 4.42 MHz - 0.3 0.8 dB
Group Delay Variation Fo 4.42 MHz - 35 60 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB 9.80 10.17 - MHz 
-3 dB - 10.64 -
-30 dB - 12.28 -
-40 dB - 12.53 12.80
Absolute Delay Fo - 1.55 - usec
Ultimate Rejection - 43 48 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL75.0M-10B

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map