IF SAW Filter
Part Number Package Application Last Modified
813-SL70.0M-19A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL70.0M-19A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 70.00 - MHz
Insertion Loss Fo - 12.8 15.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -40 - +85 C
Storage Temperature - -45 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Fo 9.22 MHz - 0.55 1.00 dB
Group Delay Variation Fo 9.22 MHz - 50 100 nsec
Ultimate Rejection - 40 45 - dB
Bandwidth -1 dB 19.00 19.30 - MHz 
-3 dB - 19.95 -
-40 dB - 22.95 23.20
Absolute Delay - - 1.16 - usec
Relative Attenuation Fo + 10.80 MHz 15 18 - dB
Fo - 10.80 MHz 15 16 - dB
Temperature Coefficient Fo 9.22 MHz - -86 - ppm/C
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL70.0M-19A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map