IF SAW Filter
Part Number Package Application Last Modified
813-IF70.0M-14D 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-IF70.0M-14D

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 70.0 - MHz
Insertion Loss Fo - 23.3 25.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 7.15 MHz - 0.63 1.00 dB
Group Delay Variation Fo 7.15 MHz - 30 70 nsec
Temperature Coefficient - - -72 - ppm/C
Bandwidth -1 dB 14.80 14.90 - MHz 
-3 dB - 15.33 -
-40 dB - 17.20 17.45
Absolute Delay Fo - 1.65 - usec
Relative Attenuation Fo 8.3 MHz 15 17 - dB
Ultimate Rejection - 45 48 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF70.0M-14D

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map