IF SAW Filter
Part Number Package Application Last Modified
813-IF70.0M-13A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :

813-IF70.0M-13A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 69.5 70.0 70.5 MHz
Insertion Loss Fo - 11.7 13.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -40 - +85 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 5.75 MHz - 0.40 0.80 dB
Group Delay Variation Fo 5.75 MHz - 26 80 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB 13.60 13.96 - MHz 
-3 dB 14.40 14.75 -
-40 dB - 18.30 19.80
Absolute Delay Fo - 0.85 - usec
Relative Attenuation 0.1 ~ 55.0 MHz 50 55 - dB
55.0 ~ 60.0 MHz 40 44 -
63.35 ~ 76.65 MHz - 1.00 3.00
80.0 ~ 85.0 MHz 40 45 -
85.0 ~ 110.0 MHz 50 52 -
Phase Linearity Fo 5.75 MHz - 3.70 50.00 deg
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF70.0M-13A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map