IF SAW Filter
Part Number Package Application Last Modified
813-IF65.8M-07A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-IF65.8M-07A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 65.8 - MHz
Insertion Loss Fo - 20.6 22.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -5 - +65 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 3.50 MHz - 0.60 - dB
Group Delay Variation Fo 3.50 MHz - 32 60 nsec
Temperature Coefficient - - -72 - ppm/C
Bandwidth -1 dB 7.40 7.60 - MHz 
-3 dB - 8.05 -
-25 dB - 9.60 9.80
-40 dB - 10.00 10.30
Absolute Delay Fo - 1.65 - usec
Relative Attenuation Lower Sidelobe 47 50 - dB
Upper Sidelobe 47 50 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF65.8M-07A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map