IF SAW Filter
Part Number Package Application Last Modified
813-IF264.0-15A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-IF264.0M-15A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 264.0 - MHz
Insertion Loss Fo - 25.5 28.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple - - 0.60 1.00 dB
Group Delay Variation - - 38 80 nsec
Temperature Coefficient - - -20 - ppm/C
Bandwidth -1 dB 15.00 15.35 - MHz 
-3 dB - 15.48 -
-25 dB - 17.25 17.50
-40 dB - 17.66 17.90
Absolute Delay Fo - 2.02 - usec
Relative Attenuation Lower Sidelobe 48 52 - dB
Upper Sidelobe 48 52 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF264.0M-15A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map