IF SAW Filter
Part Number Package Application Last Modified
813-SL142.5M-50A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-SL142.5M-50A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - 142.35 142.50 142.65 MHz
Insertion Loss Fo - 12.7 15.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +85 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 2.2 MHz - 0.3 0.8 dB
Group Delay Variation Fo 2.2 MHz - 40 80 nsec
Temperature Coefficient - - -18 - ppm/C
Bandwidth -1 dB 5.0 5.2 - MHz 
-3 dB - 5.8 -
-35 dB - 8.0 8.5
Absolute Delay Fo - 1.17 - usec
Relative Attenuation Lower Sidelobe 45 48 - dB
Upper Sidelobe 45 48 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SLxM-x

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map