IF SAW Filter
Part Number Package Application Last Modified
813-SL125.0M-10A 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :

813-SL125.0M-10A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 125.0 - MHz
Insertion Loss Fo - 17.5 20.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple Variation Fo 4.7MHz - 0.30 0.70 dB
Group Delay Variation Fo 4.7 MHz - 20 70 nsec
Temperature Coefficient - - -18 - ppm/C
Bandwidth -1 dB 10.00 10.85 - MHz 
-3 dB - 11.45 -
-40 dB - 13.80 14.50
Absolute Delay Fo - 1.34 - usec
Relative Attenuation Lower Sidelobe 40 50 - dB 
Upper Sidelobe 40 50 -
Fo 55 MHz 50 60 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-SL125.0M-10A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map