IF SAW Filter
Part Number Package Application Last Modified
813-IF120.0M-19D 13.3 x 6.5 SMD IF SAW Filter January 2011

PART NUMBER :
813-IF120.0M-19D

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 120.0 - MHz
Insertion Loss Fo - 21.0 24.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 9.22 MHz - 0.65 1.00 dB
Group Delay Variation Fo 9.22 MHz - 37 80 nsec
Temperature Coefficient - - -72 - ppm/C
Bandwidth -1 dB - 19.48 - MHz 
-3 dB 19.80 19.90 -
-40 dB - 21.75 22.0
Absolute Delay Fo - 1.52 - usec
Relative Attenuation Center of 1FA - 3.5 MHz 15 35 - dB
Center of 4FA + 3.5 MHz 15 32 -
Ultimate Rejection - 45 50 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, D, F, G, H, I, J, L Ground
K In
E Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
813-IF120.0M-19D

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map