IF SAW Filter
Part Number Package Application Last Modified
809-SL75.1M-27C

9.1 x 4..8 SMD

IF SAW Filter January 2011

PART NUMBER :
809-SL75.1M-27C

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.1 - MHz
Insertion Loss Fo - 18.2 19.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 12.5 MHz - 0.3 0.6 dB
Group Delay Variation Fo 12.5 MHz - 15 35 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1.0 dB - 27.5 - MHz 
-3.0 dB - 28.4 -
-30.0 dB - 32.4 38.8
Absolute Delay Fo - 0.83 - usec
Relative Attenuation Lower Sidelobe 30 40 - dB
Upper Sidelobe 30 40 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL75.1M-27C

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map