IF SAW Filter
Part Number Package Application Last Modified
809-SL75.0M-21C 9.1 x 4.8 SMD IF SAW Filter January 2011

PART NUMBER :
809-SL75.0M-21C

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.0 - MHz
Insertion Loss Fo - 14.0 16.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -20 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Amplitude Ripple Variation Fo 9.75 MHz - 0.3 0.8 dB
Group Delay Variation Fo 9.75 MHz - 22 40 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB 21.30 21.60 - MHz 
-3 dB - 23.00 -
-20 dB - 26.90 27.20
-40 dB - 29.35 -
Absolute Delay Fo - 0.607 - usec
Relative Attenuation Lower Sidelobe 40 45 - dB
Upper Sidelobe 4 45 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL75.0M-21C

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map