IF SAW Filter
Part Number Package Application Last Modified
809-SL75.0M-15D 9.1 x 4.8 SMD IF SAW Filter January 2011

PART NUMBER :
809-SL75.0M-15D

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 75.00 - MHz
Insertion Loss Fo -

13.50

15.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Absolute Delay Time Fo - 0.96 - usec
Group Delay Variation Fo 6.875 MHz - 30 60 nsec
Temperature Coefficient - - -86 - ppm/C
Bandwidth -1 dB - 14.80 - MHz 
-3 dB -

15.67

-
-40 dB - 19.85 20.50
Passband Ripple Fo 6.875 MHz - 0.46 0.80 dB
Ultimate Rejection - 40 47 - dB
VSWR - - 3 - -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL75.0M-15D

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map