IF SAW Filter
Part Number Package Application Last Modified
809-SL62.9M-20E 9.1 x 4.8 SMD IF SAW Filter January 2011

PART NUMBER :
809-SL62.9M-20E

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 62.9 - MHz
Insertion Loss Fo MHz - 18.0 20.5 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +80 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Passband Ripple 62.5 MHz 9.75 MHz - 0.30 1.0 dB
Group Delay Variation 62.5 MHz 9.75 MHz - 20 40 nsec
Absolute Delay Fo - 0.91 - usec
Bandwidth -1 dB 20.7 21.2 - MHz 
-3 dB 21.8 22.2 -
-20 dB - 24.9 -
-30 dB - 25.6 26.5
-40 dB - 26.9 28.0
Relative Attenuation 62.5 -12.5MHz 35 40 - dB
Lower Sidelobe 40 45 -
Upper Sidelobe 40 45 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL62.9M-20E

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map