IF SAW Filter
Part Number Package Application Last Modified
809-SL62.5M-16A 9.1 x 4.8 SMD IF SAW Filter January 2011

PART NUMBER :
809-SL62.5M-16A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 62.50 - MHz
Insertion Loss Fo - 15.00 17.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -30 - +60 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Absolute Delay Fo - 0.88 - usec
Group Delay Variation Fo 7 MHz - 25 50 nsec
Passband Ripple Fo 7 MHz - 0.25 0.70 dB
Bandwidth -1 dB 16.40 16.60 - MHz 
-3 dB - 17.57 -
-40 dB - 21.56 22.00
Relative Attenuation Lower Sidelobe 40 45 - dB
Upper Sidelobe 40 45 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL62.5M-16A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map