IF SAW Filter
Part Number Package Application Last Modified
809-SL108.4M-02A 9.1 x 4.8 SMD IF SAW Filter January 2011

PART NUMBER :
809-SL108.4M-02A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 108.40 - MHz
Insertion Loss Fo - 11.60 14.00 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -5 - +70 C
Storage Temperature - -40 - +85 C
Source Impedance single ended * - 50 - ohm
Load Impedance single ended * - 50 - ohm
Absolute Delay Fo - 0.89 - usec
Group Delay Variation Fo 0.9 MHz - 10 40 nsec
Temperature Coefficient - - -20 - ppm/C
Bandwidth -1 dB 2.00 3.20 - MHz 
-3 dB - 4.05 -
-40 dB - 7.10 8.00
Passband Ripple Fo 0.9 MHz - 0.20 0.70 dBm
Ultimate Rejection - 45 50 - dB
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
1, 3, 4, 5, 6, 8, 9, 10 Ground
2 In
7 Out

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
809-SL108.4M-02A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map