IF SAW Filter
Part Number Package Application Last Modified
807-SL133.2M-02A 7.0 x 5.0 SMD IF SAW Filter January 2011

PART NUMBER :
807-SL133.2M-02A

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 133.2 - MHz
Insertion Loss at Fo (including losses in matching circuit) - 4.5 8.0 dB
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -40 - +85 C
Storage Temperature - -40 - +85 C
Source Impedance single/balanced ended * - 50/200 - ohm
Load Impedance single/balanced ended * - 50/200 - ohm
Amplitude Ripple Variation Fo 100.0 KHz - 0.50 1.00 dB
Group Delay Variation Fo 100.0 KHz - 300.0 1000.0 nsec
Temperature Coefficient - - -0.036 - ppm/C
Bandwidth -3 dB - 430.0 - KHz 
Relative Attenuation Fc 250.0 KHz ~ Fc 400.0KHz 3 5 - dB
Fc 400.0 KHz ~ Fc 600.0KHz 15 16 -
Fc 600.0 KHz ~ Fc 800.0KHz 20 28 -
Fc 800.0 KHz ~ Fc 3.0MKHz 29 31 -
Fc 3.0 MHz ~ Fc 7.0MHz 35 42 -
Fc 7.0 MHz ~ Fc 30.0MHz 40 47 -
* With Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A, B, C, F, G, H Ground
I In
J In or Ground
D Out
E Out or Ground

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
807-SL133.2M-02A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map